A trade-off design of microstrip broadband power amplifier for UHF applications

Mohamed Ribate, Rachid Mandry, Jamal Zbitou, Larbi El Abdellaoui, Ahmed Errkik, Mohamed Latrach, Ahmed Lakhssassi

Abstract


In this paper, the design of a Broadband Power Amplifier for UHF applications is presented. The proposed BPA is based on ATF13876 Agilent active device. The biasing and matching networks both are implemented by using microstrip transmission lines. The input and output matching circuits are designed by combining two broadband matching techniques: a binomial multi-section quarter wave impedance transformer and an approximate transformation of previously designed lumped elements. The proposed BPA shows excellent performances in terms of impedance matching, power gain and unconditionally stability over the operating bandwidth ranging from 1.2 GHz to 3.3 GHz. At 2.2 GHz, the large signal simulation shows a saturated output power of 18.875 dBm with an output 1-dB compression point of 6.5 dBm of input level and a maximum PAE of 36.26%.

Keywords


Binomial transformer; Broadband biasing; Broadband power amplifier; Impedance matching; Microstrip; UHF Band

Full Text:

PDF


DOI: http://doi.org/10.11591/ijece.v10i1.pp919-927

Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.

International Journal of Electrical and Computer Engineering (IJECE)
p-ISSN 2088-8708, e-ISSN 2722-2578

This journal is published by the Institute of Advanced Engineering and Science (IAES) in collaboration with Intelektual Pustaka Media Utama (IPMU).