Enhancement of power quality using microprocessor based shunt active power filter for unbalanced load

Madhu B. R., Dinesh M. N., Tsewang Thinlas, Deril Menezes

Abstract


Power quality is the most significant factor of power sector. The end user equipment such as induction motor, inverters, rectifiers inject harmonics into power system that influences the quality of power delivered. The presence of harmonics forces the use of instantaneous reactive power theory to calculate instantaneous power that helps in finding the compensating currents to eliminate harmonics. The control action required by active filter is accomplished by STM32F303RET6 microcontroller. Single phase induction motor is used as a dynamic nonlinear load in one of the three phases and resistive loads on the other two phases. TRIAC based RC triggering circuit was used to control the single phase induction motor. This paper presents the simulation and hardware implementation of shunt active power filter for 3 phase 4 wire unbalanced system. The hardware results show that THD in the source side has been reduced from 50.7% to 9.6% by implementing the SAPF.

Keywords


Instantaneous reactive power theory; Shunt Active Power Filter (SAPF); STM32F303RET6 Micro-controller; Three phase three leg IGBT inverter

Full Text:

PDF


DOI: http://doi.org/10.11591/ijece.v10i4.pp3393-3402

Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.

International Journal of Electrical and Computer Engineering (IJECE)
p-ISSN 2088-8708, e-ISSN 2722-2578

This journal is published by the Institute of Advanced Engineering and Science (IAES) in collaboration with Intelektual Pustaka Media Utama (IPMU).