Automation of DMPS Manufacturing by using LabView & PLC

Fareeza F, Chunchu Rambabu, S. Krishnaveni, Abel Chernet Kabiso

Abstract


This Paper is to enable the Siemens (Programmable Logic Control) CPU 313-5A to communicate with the Lab VIEW and to control the process accuracy by image processing. The communication between CPU 313-5A and Lab VIEW is via OPC (OLE for Process Control).Process Accuracy is achieved with the use of Labview Image Processing and Gray Scale matching Pattern. Accuracy in the gray scale matching will purely depend on the calibration of the camera with respect to the corresponding image. The digital output from the labview is communicated to PLC via Ethernet Protocol for the industrial process control. With the use of Labview the dead time while using the normal image vision module in PLC can be minimized. Labview uses the gray scale matching technique which is more accurate than the normal image vision module used in PLC.


Keywords


LabView PLC Process Control Camera Ethernet

Full Text:

PDF


DOI: http://doi.org/10.11591/ijece.v8i6.pp5484-5494

Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.

International Journal of Electrical and Computer Engineering (IJECE)
p-ISSN 2088-8708, e-ISSN 2722-2578

This journal is published by the Institute of Advanced Engineering and Science (IAES) in collaboration with Intelektual Pustaka Media Utama (IPMU).